Quarry and Victorian Tiles Repaired, Cleaned and Sealed in Swansea

The owner of this property in Swansea contacted me recently about a two-part job that would involve the restoration of both a Quarry tiled hallway and a Victorian tiled lobby. The property itself dates back to 1918 – making it nearly a century old – and its safe to assume that both sets of tiles are of a similar age. As you can see from the photographs, they had certainly had absorbed a lot of wear and tear over the years, and as these tiles get older it becomes in increasingly difficult to maintain their appearance.

Cleaning a Quarry Tiled Hallway

A number of the Quarry tiles had at some point in the past been removed to allow the installation of electrical cables below ground, with an unsightly layer of cement left in their place. At a later point I would need to replace these tiles, but initially I needed to remove the old cement, along with any old sealer remaining on the floor by applying and scrubbing in Tile Doctor Remove & Go.

Next, I applied an undiluted solution of Tile Doctor Pro Clean, our effective alkaline tile cleaner, to break down and remove the ingrained dirt. I then rinsed with clean water, and removed the resulting slurry with a wet vacuum. With the floor freshly cleaned, I proceeded to retile the area where tiles were missing.

Cleaning a Victorian Tiled Lobby

The Victorian tiles in the porch/lobby room area were adjoined to the Quarry tiles. In this area there were several loose tiles, and I opted to recement and regrout them before beginning a clean.

Following this the tiles were treated to a thorough clean in a similar fashion to that provided to the Quarry tiles, however, in this case I mixed Remove and Go and Pro Clean to form a powerful cleaning solution. This was applied to the floor, left to dwell for a short period, and then scrubbed into the tiles, quickly bringing them back to life. I then lightly steamed cleaned the floor with a Karcher tool to eliminate or neutralise any chemicals that remained.

Sealing Quarry and Victorian Tiles

I left the two sets of tiles to dry out fully overnight. Upon my return to the property, I ran damp tests to confirm that the floors were ready to be sealed. The customer had asked for a satin finish on both floors, so I decided to use Tile Doctor Seal and Go. This topical sealer provides a durable sheen seal, and is a cost-effective option for Quarry and Victorian tiles. I applied seven coats of Seal and Go in total across both sets of tiles.

The customer and myself were delighted with the results. In the space of just a couple of days these classic tiles have been brought been completely revitalised, and thanks to the application of a fresh sealer will be easier for the customer to keep clean going forward.

Restoration of an Old Quarry Tiled Hallway and Victorian Tiled Lobby in South Wales